PB CTRL should do what you want. See page 62 of the K3S manual. Jack, W6FB
> On Jun 30, 2018, at 7:31 PM, Michael Gillen via Elecraft > <[email protected]> wrote: > > Good info on the filters I had never tried the LO/HI CUT and I like it. One > question: On my K3S I cannot set the LO CUT to .35KHz it only steps in .10 > increments not 0.05 increments is there some CONFIG item I need to change? I > looked through the CONFIG menus and Fred Cady’s book however I did not see > anything about setting that step. > > 73, > Michael > KK6RWK > > >> On Jun 30, 2018, at 5:37 PM, Bill Frantz <[email protected]> wrote: >> >> Congratulations. The K3 is a really nice radio with extraordinary factory >> support. >> >> For SSB, I set low cut to .35 KHz and adjust the upper cut between 1.9 KHz >> and 2.8 KHz, depending on conditions. Higher makes for easier copy, but >> lower will eliminate more noise, and help with nearby stations. Remember, >> the crystal filters are to protect the AtoD converter in the receiver. The >> DSP has many useful settings between those of the installed filters. >> >> 73 Bill AE6JV >> >> On 6/30/18 at 5:07 PM, [email protected] (Bill) wrote: >> >>> I recently purchased a K3 and trying to set up for SSB.I do not do code. >>> Is there any recommended settings for the shift lo cut and width? >>> It has the KFL3A-400 and the KFL3A-12.8 8 pole filters installed >>> I have read the manual and it does not really help me. >>> Thanks >>> Bill >>> W3WGG >> >> --------------------------------------------------------------------------- >> Bill Frantz | Re: Computer reliability, performance, and security: >> 408-356-8506 | The guy who *is* wearing a parachute is *not* the >> www.pwpconsult.com | first to reach the ground. - Terence Kelly >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
