Hmmm when I try that I get Shif=.05 however and when I turn VFO-A it says N/A and it still moves in .10 increments?
> On Jun 30, 2018, at 7:55 PM, Jack Brindle <[email protected]> wrote: > > PB CTRL should do what you want. See page 62 of the K3S manual. > > Jack, W6FB > >> On Jun 30, 2018, at 7:31 PM, Michael Gillen via Elecraft >> <[email protected]> wrote: >> >> Good info on the filters I had never tried the LO/HI CUT and I like it. One >> question: On my K3S I cannot set the LO CUT to .35KHz it only steps in .10 >> increments not 0.05 increments is there some CONFIG item I need to change? I >> looked through the CONFIG menus and Fred Cady’s book however I did not see >> anything about setting that step. >> >> 73, >> Michael >> KK6RWK >> >> >>> On Jun 30, 2018, at 5:37 PM, Bill Frantz <[email protected]> wrote: >>> >>> Congratulations. The K3 is a really nice radio with extraordinary factory >>> support. >>> >>> For SSB, I set low cut to .35 KHz and adjust the upper cut between 1.9 KHz >>> and 2.8 KHz, depending on conditions. Higher makes for easier copy, but >>> lower will eliminate more noise, and help with nearby stations. Remember, >>> the crystal filters are to protect the AtoD converter in the receiver. The >>> DSP has many useful settings between those of the installed filters. >>> >>> 73 Bill AE6JV >>> >>> On 6/30/18 at 5:07 PM, [email protected] (Bill) wrote: >>> >>>> I recently purchased a K3 and trying to set up for SSB.I do not do code. >>>> Is there any recommended settings for the shift lo cut and width? >>>> It has the KFL3A-400 and the KFL3A-12.8 8 pole filters installed >>>> I have read the manual and it does not really help me. >>>> Thanks >>>> Bill >>>> W3WGG >>> >>> --------------------------------------------------------------------------- >>> Bill Frantz | Re: Computer reliability, performance, and security: >>> 408-356-8506 | The guy who *is* wearing a parachute is *not* the >>> www.pwpconsult.com | first to reach the ground. - Terence Kelly >>> >>> ______________________________________________________________ >>> Elecraft mailing list >>> Home: http://mailman.qth.net/mailman/listinfo/elecraft >>> Help: http://mailman.qth.net/mmfaq.htm >>> Post: mailto:[email protected] >>> >>> This list hosted by: http://www.qsl.net >>> Please help support this email list: http://www.qsl.net/donate.html >>> Message delivered to [email protected] >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
