I've been using my K3 & K3s for years using the DATA mode. It has worked as if it were in the USB mode, and shows on the P3 scope to the right of the dial frequency just like a USB signal would.
Today I tried 60 meters for the first time. I could pick up signals and decode them just fine in USB mode, and the P3 showed the signals to the right of the dial frequency as expected. However, when I shifted the radio into DATA mode, the P3 seemed to shift as if it was showing a double sideband signal (half below the suppressed carrier and half above). At this point, when in DATA mode, nothing would decode until I selected REV DATA. The result of that was that calculated frequencies were wrong (appearing that signals were significantly outside the US channel limit. Am I missing some setting, or is there something unique about how the DATA mode works on 60 meters? 73, Bob, WB4SON ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
