That is normal to comply with the 60M frequency and BW allowed. 73 Bob, K4TAX
Sent from my iPhone > On Jan 31, 2019, at 5:15 PM, Bob <[email protected]> wrote: > > I've been using my K3 & K3s for years using the DATA mode. It has worked > as if it were in the USB mode, and shows on the P3 scope to the right of > the dial frequency just like a USB signal would. > > Today I tried 60 meters for the first time. I could pick up signals and > decode them just fine in USB mode, and the P3 showed the signals to the > right of the dial frequency as expected. However, when I shifted the radio > into DATA mode, the P3 seemed to shift as if it was showing a double > sideband signal (half below the suppressed carrier and half above). At > this point, when in DATA mode, nothing would decode until I selected REV > DATA. The result of that was that calculated frequencies were wrong > (appearing that signals were significantly outside the US channel limit. > > Am I missing some setting, or is there something unique about how the DATA > mode works on 60 meters? > > 73, Bob, WB4SON > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
