Glad to be of service. Sent from my iPhone ...nr4c. bill
> On Feb 1, 2019, at 10:39 AM, Bob McGraw K4TAX <[email protected]> wrote: > > Thanks and always glad to assist. And glad you have the issue resolved. > > 73 > > Bob, K4TAX > >> On 2/1/2019 9:22 AM, Bob wrote: >> Both Bob K4TAX and Bill NR4C figured out the problem... >> >> I've been using my K3s for a few years on all bands except 60 meters. So my >> original setup was from a long time ago. At that time I set all my active >> bands to DATA MD DATA A. When I tried 60 meters for the first time >> yesterday to help someone who needed RI for their WAS, I didn't think to >> check DATA MD on the 60 meter band. I suspect it defaults to AFSK, which >> is a LSB mode. >> >> So moral of the story -- if you have to be in REV DATA you probably haven't >> set the DATA MD to DATA A >> >> 73, Bob, WB4SON >> >>> On Thu, Jan 31, 2019 at 9:16 PM Nr4c <[email protected]> wrote: >>> >>> Which DATA sub-mode were you using. There are two USB and two LSB >>> sub-modes. >>> >>> Sent from my iPhone >>> ...nr4c. bill >>> >>> >>>> On Jan 31, 2019, at 6:15 PM, Bob <[email protected]> wrote: >>>> >>>> I've been using my K3 & K3s for years using the DATA mode. It has worked >>>> as if it were in the USB mode, and shows on the P3 scope to the right of >>>> the dial frequency just like a USB signal would. >>>> >>>> Today I tried 60 meters for the first time. I could pick up signals and >>>> decode them just fine in USB mode, and the P3 showed the signals to the >>>> right of the dial frequency as expected. However, when I shifted the >>> radio >>>> into DATA mode, the P3 seemed to shift as if it was showing a double >>>> sideband signal (half below the suppressed carrier and half above). At >>>> this point, when in DATA mode, nothing would decode until I selected REV >>>> DATA. The result of that was that calculated frequencies were wrong >>>> (appearing that signals were significantly outside the US channel limit. >>>> >>>> Am I missing some setting, or is there something unique about how the >>> DATA >>>> mode works on 60 meters? >>>> >>>> 73, Bob, WB4SON >>>> ______________________________________________________________ >>>> Elecraft mailing list >>>> Home: http://mailman.qth.net/mailman/listinfo/elecraft >>>> Help: http://mailman.qth.net/mmfaq.htm >>>> Post: mailto:[email protected] >>>> >>>> This list hosted by: http://www.qsl.net >>>> Please help support this email list: http://www.qsl.net/donate.html >>>> Message delivered to [email protected] >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> Message delivered to [email protected] >> > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
