It does NOT, and DATA A (USB) MUST be used, NOT in REV mode. Among other
things, WSJT modes won't decode if the signal is reversed. Detailed
instructions from ARRL for data modes on 60M are at the link below. FT8
operation should do the same as described for PSK31 -- set the TX
frequency for 1500Hz.
http://www.arrl.org/60m-channel-allocation
I don't work 60M, but it's my understanding that frequency allocations
on this band vary from one country to another, so it may be necessary to
work split.
73, Jim K9YC
On 1/31/2019 3:29 PM, Bob wrote:
No matter what the scope says, I don't understand why it has to be put into
DATA REV in order to decode signals obviously sent as USB.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
