We've been busy at Elecraft Engineering this week and we have just
placed new K3 firmware on the ftp site.
MCU: V 1.49
DSP: V 1.46
New Features:
Noise Reduction significantly improved. Also, NR can be used with narrow
filters in CW mode.
AM mode added. (6 kHz Filter required.)
NOTE: AM Power control temporarily works as follows: when you set power
to 100 W in AM mode, it means 100 W *peak power*, and 25 W *carrier
power*. Also, the bar graph shows peak power in AM mode. This will be
corrected later so the display and bar graph both show carrier
power.Manual notch frequency defaults to 2 kHz (originally 200 Hz).
See 'Release Notes' in the K3 Update Utility for a complete revision
history.
Enjoy! :-)
73, Eric WA6HHQ
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com