Is synchronous detection is enabled? Dale, K9VUJ
Eric Swartz - WA6HHQ, Elecraft wrote: > > We've been busy at Elecraft Engineering this week and we have just > placed new K3 firmware on the ftp site. > MCU: V 1.49 > DSP: V 1.46 > > New Features: > > Noise Reduction significantly improved. Also, NR can be used with narrow > filters in CW mode. > > AM mode added. (6 kHz Filter required.) > > NOTE: AM Power control temporarily works as follows: when you set power > to 100 W in AM mode, it means 100 W *peak power*, and 25 W *carrier > power*. Also, the bar graph shows peak power in AM mode. This will be > corrected later so the display and bar graph both show carrier > power.Manual notch frequency defaults to 2 kHz (originally 200 Hz). > > See 'Release Notes' in the K3 Update Utility for a complete revision > history. > > Enjoy! :-) > > 73, Eric WA6HHQ > > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > > -- View this message in context: http://www.nabble.com/New-K3-F-W---MCU%3A-V-1.49-DSP%3A-V-1.46-NR-Improved.-AM-added-tp14346759p14349493.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
