Under AM mode, the DSP bandwidth control seems restricted to 6KHz. Is
there any way that I can change it to 6KHz to match the AM crystal
roofing filter?
With the 6 kHz roofing filter, you should be able to set HI CUT to 3 kHz
in AM mode. My radio is not immediately at hand at the moment to verify
this. If HI CUT does not go to 3 kHz, then it will be addressed in the
next firmware update.
73,
Lyle KK7P
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
