Thanks Lyle.
Yes, I can set the HI CUT to 3Khz. Can it be increased to 6KHz to match
the AM roofing filter?
73
johnny VR2XMC
----- Original Message -----
From: "Lyle Johnson" <[EMAIL PROTECTED]>
To: "johnny" <[EMAIL PROTECTED]>
Cc: "DaleJ" <[EMAIL PROTECTED]>; <[email protected]>
Sent: Sunday, December 16, 2007 3:06 PM
Subject: Re: [Elecraft] New K3 F/W - MCU: V 1.49 DSP: V 1.46 NR Improved.AM
added
Under AM mode, the DSP bandwidth control seems restricted to 3KHz. Is
there any way that I can change it to 6KHz to match the AM crystal
roofing filter?
With the 6 kHz roofing filter, you should be able to set HI CUT to 3 kHz
in AM mode. My radio is not immediately at hand at the moment to verify
this. If HI CUT does not go to 3 kHz, then it will be addressed in the
next firmware update.
73,
Lyle KK7P
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
