John Thornton wrote:
> There is a link on the documents page to the 2.5 html docs which seem to
> be getting built as changes are made.
>
> http://www.linuxcnc.org/docview/2.5/html/
>
>
And, it apparently is NOT working, or did not get updated. If you look at
the HAL manual / Pico PPMC Driver / 2. Parameters and scan down to
ppmc.<port>.stepgen.<channel-range>.pulse-space-min
It reads :
— Sets minimum time between pulses, in units of 100ns. The maximum step
rate is Applies to a group of four consecutive step generators, as
indicated by <channel-range>.
Now, where it says the max step rate is, there is supposed to be a
fraction there, which
would appear in the PDF files, except the entire section about hardware
drivers is not
being included in the PDF build right now. The code for the fraction is
in the
asciitext file, and looks like this :
latexmath:[[\frac{1}{ ( 100ns * ( `pulse-width` + `pulse-space-min` )) }
\]].
Your other layout may be better, but I'm a LOT more concerned with just
getting
the document info built right now. If this docview link you give above is
really being rebuilt, then the latexmath part is STILL NOT WORKING for the
html version, and
a number of important documents are seriously affected by the missing
formulas. Some of the docs on motion control are entirely unreadable.
Also, the PDF docs are missing a HUGE section of hardware driver doc
pages that are present in the git docs tree,
Jon
------------------------------------------------------------------------------
The demand for IT networking professionals continues to grow, and the
demand for specialized networking skills is growing even more rapidly.
Take a complimentary Learning@Cisco Self-Assessment and learn
about Cisco certifications, training, and career opportunities.
http://p.sf.net/sfu/cisco-dev2dev
_______________________________________________
Emc-developers mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-developers
