I,ll be able to, but unfortunately I,m away until Monday Tero. Sarah
Sent from BlueMail On 3 Nov 2016, 18:04, at 18:04, "tero.kaarl...@eka-sorvaus.fi" <turo.kaarl...@co.inet.fi> wrote: >Ok, > >I added saving previous state of Speed and Feed override enable. And >restore after cycle is done. I am not sure if this is correct way of >implementing this? It has been tested and does work. Also updated for >current master. Could someone check this and tell me if it is usable or >not. > >http://personal.inet.fi/koti/ekasorvaus/linuxcnc/g84_g74.diff > > >-- >Tero Kaarlela >Production Engineer >Eka-Sorvaus OY >Nivala >Finland > >------------------------------------------------------------------------------ >Developer Access Program for Intel Xeon Phi Processors >Access to Intel Xeon Phi processor-based developer platforms. >With one year of Intel Parallel Studio XE. >Training and support from Colfax. >Order your platform today. http://sdm.link/xeonphi >_______________________________________________ >Emc-developers mailing list >Emc-developers@lists.sourceforge.net >https://lists.sourceforge.net/lists/listinfo/emc-developers ------------------------------------------------------------------------------ Developer Access Program for Intel Xeon Phi Processors Access to Intel Xeon Phi processor-based developer platforms. With one year of Intel Parallel Studio XE. Training and support from Colfax. Order your platform today. http://sdm.link/xeonphi _______________________________________________ Emc-developers mailing list Emc-developers@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-developers
