In a past life I was with a company that made deep fryers. Though the tanks were SS, we made the lids of aluminum, but they had to be 1100 series (unalloyed) aluminum to meet the requirements. Unfortunately, I don't remember what requirements.
Jack M. Burns, PE, CSP Product Safety Engineer Eaton Corporation ph: 512 248-2851 fax: 512 248-2050 email: [email protected] > -----Original Message----- > From: Mike Morrow [SMTP:[email protected]] > Sent: Thursday, August 27, 1998 8:04 AM > To: IEEE EMC Board > Subject: FDA Requirements > > I've always been told that any piece of equipment being used in a > "sanitary" application (i.e. food processing, etc) must be constructed > of > stainless steel. I'm after the actual standard that has this > requirement. Can aluminum be used?? > > Any help is appreciated. > > Mike Morrow > Product Standards Engineer > Data Instruments > [email protected] > [email protected] > Phone 978-264-9550 xt-201 > Fax 978-263-0630 > > > --------- > This message is coming from the emc-pstc discussion list. > To cancel your subscription, send mail to [email protected] > with the single line: "unsubscribe emc-pstc" (without the > quotes). For help, send mail to [email protected], > [email protected], or [email protected] (the list > administrators). --------- This message is coming from the emc-pstc discussion list. To cancel your subscription, send mail to [email protected] with the single line: "unsubscribe emc-pstc" (without the quotes). For help, send mail to [email protected], [email protected], or [email protected] (the list administrators).
