Just happen to be looking this up when you e-mail arrived. I noticed
something interesting buried in the Listing Mark data page. Paragraph 5 in
our UL report. I think they are generic pages so likely you would find it in
the same place in your reports/procedures.
The Product identity may be omitted if the Mark is directly and
permanently applied to the product, stamping, molding, ink-stamping....
I assume that is because you can't mistakenly put and ITE label on a
medical device or something during manufacture.
-----Original Message-----
From: Rich Nute [mailto:[email protected]]
Sent: Wednesday, October 17, 2001 1:57 PM
To: [email protected]
Cc: [email protected]; [email protected];
[email protected]
Subject: Re: UL - marking - gentle warning not to extrapolate.
Hi Chris:
> Does the file number need to be on the label? Can the manufacturer
> leave the file number off of the label and simply put a generic UL (or
> CSA) mark on the product along with their nameplate identifying the
> manufacturer, model and serial number?
In my response to Amund, I indicated that UL requires
a manufacturer identifier, which is usually the
manufacturer's name, but alternatively can be the UL
file number.
UL also requires a product identifier such as the model
number, but does not require a serial number.
A generic UL label is not possible. Section General of
your UL FUS Procedure identifies 4 elements that comprise
the UL certification mark:
1. The copyrighted UL mark itself (UL in a circle).
2. The word "Listed."
3. The category of equipment, e.g., "ITE" or "PRINTER."
4. The UL control number assigned to the manufacturer
for this specific category of equipment.
While you may be able to buy Item 1, or even Items 1 and
2, on a "generic" pre-printed label, you must necessarily
provide Item 3 because it describes your equipment, and
you must necessarily provide Item 4 because it is unique
to you. All of these elements must be in reasonable
proximity of each other.
I don't believe CSA has the same four requirements for its
mark. So, I believe you can buy the generic CSA mark. Be
sure to verify this statement with CSA before taking any
action.
Good luck, and best regards,
Rich
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Michael Garretson: [email protected]
Dave Heald [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
Jim Bacher: [email protected]
All emc-pstc postings are archived and searchable on the web at:
No longer online until our new server is brought online and the old
messages are imported into the new server.
-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.
Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/
To cancel your subscription, send mail to:
[email protected]
with the single line:
unsubscribe emc-pstc
For help, send mail to the list administrators:
Michael Garretson: [email protected]
Dave Heald [email protected]
For policy questions, send mail to:
Richard Nute: [email protected]
Jim Bacher: [email protected]
All emc-pstc postings are archived and searchable on the web at:
No longer online until our new server is brought online and the old
messages are imported into the new server.
