David, Please excuse me for contacting you direct.
Did you get a satisfactory answer from the forum? I ask as I just been told by a test house that the ITT-Canon CGL Industrial power connector we had wanted to use as a primary coupler is not suitable - apparently should only be used with secondary circuits. ( I believe this is the connector my colleague (boss) proposed to you via the forum ) We had assessed it against the 309 connectors for leading earth, creepage, clearance and isolation voltage. Alas the test house stated "You will find that the contacts will quickly deteriorate if you were to carry out a mating/unmating endurance test at maximum current rating." So I must find a replacement. Did you find any useful contacts I could share please. Many thanks Vic Gibling Compliance Engineer e2v technologies Ltd Waterhouse Lane Chelmsford ESSEX CM1 2QU Telephone: +44 (0) 01245 493493 Direct Line: +44 (0) 01245 453352 Facsimile: +44 (0) 01245 453410 E-mail: [email protected] Internet: www.e2vtechnologies.com This message is from the IEEE EMC Society Product Safety Technical Committee emc-pstc discussion list. Visit our web site at: http://www.ewh.ieee.org/soc/emcs/pstc/ To cancel your subscription, send mail to: [email protected] with the single line: unsubscribe emc-pstc For help, send mail to the list administrators: Ron Pickard: [email protected] Dave Heald: [email protected] For policy questions, send mail to: Richard Nute: [email protected] Jim Bacher: [email protected] Archive is being moved, we will announce when it is back on-line. All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc
