2014-05-17 16:58 GMT+03:00 Peter C. Wallace <p...@mesanet.com>: > > Did you set the fault input polarity for all pwmgens? >
Yes, fault-invert was set to 1 for all pwmgens, so that fault pin would be "false". I checked and they were all "false". I commented out fault-invert lines for first 2 instances of pwmgens and then fault was "true" for these pwmgens, so I set it back. I tested ability to jog motors that are connected to 7i39, attached to P3 - they worked fine. I swapped cards _and_ 50pin cable and the other board also works fine, if attached to P3. All LEDs also turn on and off, so it is not that pwmgens actually are enabled and board should work, but the LEDs would just not shine So the problem is either in 5i24 or in config. Enable pins for all 4 pwmgens are set "true" and all fault pins are "false". What else could it be and what should I check? Viesturs ------------------------------------------------------------------------------ "Accelerate Dev Cycles with Automated Cross-Browser Testing - For FREE Instantly run your Selenium tests across 300+ browser/OS combos. Get unparalleled scalability from the best Selenium testing platform available Simple to use. Nothing to install. Get started now for free." http://p.sf.net/sfu/SauceLabs _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
