On 20 October 2014 07:07, craig <cr...@facework.com> wrote: > 1. Wat is the minimum reading needed to migrate a simple gantry, steper > controlled router (or mill) from Mach3 to LinuxCNC
That rather depends on how Mach3 is controlling the gantry. Is this a gantry with a motor at each end? If so, how is homing configured? One stepgen or two? > 2. What elements/codes might need editing in existing g-code files? > What would you look for (scan for) in files to flag the possible need > for editing? G-code files without any custom codes should run without modification. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ Comprehensive Server Monitoring with Site24x7. Monitor 10 servers for $9/Month. Get alerted through email, SMS, voice calls or mobile push notifications. Take corrective actions from your mobile device. http://p.sf.net/sfu/Zoho _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
