On 19 Oct 2014, at 20:42, Marshland Engineering wrote:

> I'm about to start my 3 or 4 attempt to get LinuxCNC running. So far over the
> past 5 years I have spent several 100 hours trying to get things to work with
> little success.
> 
> Bear in mind that it's not just LinuxCNC, it is all of Linux you have to learn
> etc, Git Gedit repository Sudo etc. 
> 

Actually, I did it without much of that knowledge. Start with the recommended 
fresh installation procedure and go with the current stable version and the 
recommended version of Linux.
I installed Linux then installed LinuxCNC.
The bit I found a bit awkward was a little later on when I found I had to deal 
with the Update Manager.
Not a major headache, though.

Marcus

> I must say that with steppers (which we have had running) is quite simple. Now
> using Mesa bits and servo drives was a complete headache. I suppose 2 kw
> motors are a different beast. 
> 
> I have put time aside in Nov and Dec this year to try and get it going again.
> Wish me luck. 
> 
> Thanking you
> Wallace Weideman
> Marshland Engineering
> 704 Marshland Road
> Styx
> Christchurch
> 03 3237449
> www.marshland.co.nz
> 
> 
> ------------------------------------------------------------------------------
> Comprehensive Server Monitoring with Site24x7.
> Monitor 10 servers for $9/Month.
> Get alerted through email, SMS, voice calls or mobile push notifications.
> Take corrective actions from your mobile device.
> http://p.sf.net/sfu/Zoho
> _______________________________________________
> Emc-users mailing list
> Emc-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/emc-users


------------------------------------------------------------------------------
Comprehensive Server Monitoring with Site24x7.
Monitor 10 servers for $9/Month.
Get alerted through email, SMS, voice calls or mobile push notifications.
Take corrective actions from your mobile device.
http://p.sf.net/sfu/Zoho
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to