""Make"" magazine a while back had a nice table of glues vs applications that I found useful.
Dick ----- Original Message ----- From: "Gene Heskett" <[email protected]> To: <[email protected]> Sent: Thursday, August 25, 2016 9:25 AM Subject: [Emc-users] Silly Q about glues > Greetings; > > Trying to carve the toolpost support for the little monster, on the > little monster. I had it lopsided in the chuck, roughly centered on the > QC's bolt hole. But that meant the chuck jaws were turned around and I > couldn't get to the bottom 9/16 of an inch because of flying jaws . I > needed the cutaway down to perhaps 3mm of the carriage sled, so I wrote > some gcode to cut the hollowed out curve. I was going to see if I could > put it on the faceplate, but its a full 7" in diameter and hits the > motor & electronics box on the back of the lathe. > > So that was out. I put the 5" 4 jaw back on, w/o the jaws, putting a live > center in the tailstock, I ran it out far enough to get some saddle > movement room but left it pushing about 100lbs worth and ran a line of > fresh superglue all the way around it.. > > Setting up the start-stop and done settings in my gcode, I had a good > pressure on it, and had cleaned the face of the chuck with acetone, so > superglue should have stuck it for a non-slip grip. Peeled it loose on > the third touch of the tool. 3 times now, with longer setting times each > time. > > If I can find it, I've some double stick tape, or does someone else have > an even better idea? > > Thanks. > > Cheers, Gene Heskett > -- > "There are four boxes to be used in defense of liberty: > soap, ballot, jury, and ammo. Please use in that order." > -Ed Howdershelt (Author) > Genes Web page <http://geneslinuxbox.net:6309/gene> > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
