Sorry, Gene. My mags are down at the ranch and I'm picking apples up here at the farm. I'll look up the reference as soon as I have a chance.
Richard. ----- Original Message ----- From: "Gene Heskett" <[email protected]> To: <[email protected]> Sent: Thursday, August 25, 2016 10:00 AM Subject: Re: [Emc-users] Silly Q about glues > On Thursday 25 August 2016 12:35:40 R.L. Wurdack wrote: > >> ""Make"" magazine a while back had a nice table of glues vs >> applications that I found useful. >> >> Dick >> > I just spent half an hour clicking "more" without finding it. > > Thank you for trying. >> >> ----- Original Message ----- >> From: "Gene Heskett" <[email protected]> >> To: <[email protected]> >> Sent: Thursday, August 25, 2016 9:25 AM >> Subject: [Emc-users] Silly Q about glues >> >> > Greetings; >> > >> > Trying to carve the toolpost support for the little monster, on the >> > little monster. I had it lopsided in the chuck, roughly centered on >> > the QC's bolt hole. But that meant the chuck jaws were turned around >> > and I couldn't get to the bottom 9/16 of an inch because of flying >> > jaws . I needed the cutaway down to perhaps 3mm of the carriage >> > sled, so I wrote some gcode to cut the hollowed out curve. I was >> > going to see if I could put it on the faceplate, but its a full 7" >> > in diameter and hits the motor & electronics box on the back of the >> > lathe. >> > >> > So that was out. I put the 5" 4 jaw back on, w/o the jaws, putting a >> > live center in the tailstock, I ran it out far enough to get some >> > saddle movement room but left it pushing about 100lbs worth and ran >> > a line of fresh superglue all the way around it.. >> > >> > Setting up the start-stop and done settings in my gcode, I had a >> > good pressure on it, and had cleaned the face of the chuck with >> > acetone, so superglue should have stuck it for a non-slip grip. >> > Peeled it loose on the third touch of the tool. 3 times now, with >> > longer setting times each time. >> > >> > If I can find it, I've some double stick tape, or does someone else >> > have an even better idea? >> > >> > Thanks. >> > >> > Cheers, Gene Heskett >> > -- >> > "There are four boxes to be used in defense of liberty: >> > soap, ballot, jury, and ammo. Please use in that order." >> > -Ed Howdershelt (Author) >> > Genes Web page <http://geneslinuxbox.net:6309/gene> >> > >> > -------------------------------------------------------------------- >> >---------- _______________________________________________ >> > Emc-users mailing list >> > [email protected] >> > https://lists.sourceforge.net/lists/listinfo/emc-users >> >> ---------------------------------------------------------------------- >>-------- _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users > > > Cheers, Gene Heskett > -- > "There are four boxes to be used in defense of liberty: > soap, ballot, jury, and ammo. Please use in that order." > -Ed Howdershelt (Author) > Genes Web page <http://geneslinuxbox.net:6309/gene> > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
