On Thursday 25 August 2016 12:35:40 R.L. Wurdack wrote: > ""Make"" magazine a while back had a nice table of glues vs > applications that I found useful. > > Dick > I just spent half an hour clicking "more" without finding it.
Thank you for trying. > > ----- Original Message ----- > From: "Gene Heskett" <[email protected]> > To: <[email protected]> > Sent: Thursday, August 25, 2016 9:25 AM > Subject: [Emc-users] Silly Q about glues > > > Greetings; > > > > Trying to carve the toolpost support for the little monster, on the > > little monster. I had it lopsided in the chuck, roughly centered on > > the QC's bolt hole. But that meant the chuck jaws were turned around > > and I couldn't get to the bottom 9/16 of an inch because of flying > > jaws . I needed the cutaway down to perhaps 3mm of the carriage > > sled, so I wrote some gcode to cut the hollowed out curve. I was > > going to see if I could put it on the faceplate, but its a full 7" > > in diameter and hits the motor & electronics box on the back of the > > lathe. > > > > So that was out. I put the 5" 4 jaw back on, w/o the jaws, putting a > > live center in the tailstock, I ran it out far enough to get some > > saddle movement room but left it pushing about 100lbs worth and ran > > a line of fresh superglue all the way around it.. > > > > Setting up the start-stop and done settings in my gcode, I had a > > good pressure on it, and had cleaned the face of the chuck with > > acetone, so superglue should have stuck it for a non-slip grip. > > Peeled it loose on the third touch of the tool. 3 times now, with > > longer setting times each time. > > > > If I can find it, I've some double stick tape, or does someone else > > have an even better idea? > > > > Thanks. > > > > Cheers, Gene Heskett > > -- > > "There are four boxes to be used in defense of liberty: > > soap, ballot, jury, and ammo. Please use in that order." > > -Ed Howdershelt (Author) > > Genes Web page <http://geneslinuxbox.net:6309/gene> > > > > -------------------------------------------------------------------- > >---------- _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > ---------------------------------------------------------------------- >-------- _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
