On Sun, 2017-04-23 at 08:21 -0400, Todd Zuercher wrote: > With a stepper that usually means the motor is stalled usually because of too > high velocity, acceleration, or a wiring problem (bad connection on one > phase).
the motor moves accordingly when I jog in Axis interface, and the microstep scale is ok I think if a bad connection was there, the motor could not move > ----- Original Message ----- > From: "Valerio Bellizzomi" <vale...@selnet.org> > To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> > Sent: Sunday, April 23, 2017 2:46:03 AM > Subject: Re: [Emc-users] how to configure motors in pncconf? > > On Sat, 2017-04-22 at 10:24 +0200, Valerio Bellizzomi wrote: > > On Fri, 2017-04-21 at 11:56 +0100, andy pugh wrote: > > > On 21 April 2017 at 11:45, Valerio Bellizzomi <vale...@selnet.org> wrote: > > > > The X stepgen is show as 5 in the tab, and as > > > > hm2_5i25.0.stepgen.05.counts in the test window, and it is changing > > > > while I press the movement button > > > > > > I think this is the problem. > > > > > > https://github.com/LinuxCNC/hostmot2-firmware/blob/master/src/PIN_7I76x2_34.vhd > > > > > > Shows stepgen.05 to be on the expansion connector, not the DB25. > > > > > > Configure the X axis to be on Connector 3. > > Hello, > What does it means when motor vibrates and makes sounds ? > > The test window of pncconf is limited to 5000 and has disabled arrow > control, that means we can't set nothing higher than 5000. So, once > generated the config files with pncconf, I have edited the files by > hand, and now I am testing with Axis. > > now I have set the parameters as follows: > > step on-time 5000 > step space 5000 > dir setup 10000 > dir hold 10000 > > When the motor is at rest (before any jog command within Axis), it does > not vibrate. But once a command is given, when it goes at rest again it > vibrates and makes sounds, until I disable from the Axis interface. > > > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
