On 11 March 2018 at 17:36, a k <pccncmach...@gmail.com> wrote:
> i be honest, i am not smart enough to go into CURA - opensource software to
> increase step up in Z direction up to .5" and turn extruder feed off or set
> extruder feed to constant.

I just opened Cura and set the layer height to 10mm and it sliced the
model at 10mm.

The rest you can do in HAL, set the torch to "on" when the extruder
axis is moving positive and "off" when the extrude retracts.
The ddt component will do this.

"A motorcycle is a bicycle with a pandemonium attachment and is
designed for the especial use of mechanical geniuses, daredevils and
— George Fitch, Atlanta Constitution Newspaper, 1916

Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
Emc-users mailing list

Reply via email to