What update did you do? (what version of LinuxCNC are you running)

Hi Peter, thanks for answering, I think this is the identical issue that Tom also reported. I've updated both of CNC boxes to 2.7.12 of LinuxCNC. I did notice that sometimes after shutting down LinuxCNC on the PC and restarting it, the 7i43 doesnt always initialise first time, I dont know if thats got anything to do with this issue but I dont recall it happening before. My mill has the 7i43 200k gate, and my router has the 400k gate version of the same card.

The messages seem to indicate a problem in the driver, It looks like it found and configured the card, then tried again.

Peter Wallace

Thanks and Regards,

Paul.
--------------------------------------------------------------------
Contributor to: https://uhf-satcom.com http://twitter.com/UHF_Satcom
UHF Satcom Yahoo Group: http://groups.yahoo.com/group/UHF-Satcom/

IRC - pjm @ #hearsat on irc.starchat.net

Correspondents should note that all communications to this address
are automatically logged, monitored and/or recorded for lawful
or other purposes.

Skype: M0EYT_Paul
--------------------------------------------------------------------


------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to