On Tue, 7 Aug 2018, Mark Wendt wrote:
Date: Tue, 7 Aug 2018 19:17:42 -0400
From: Mark Wendt <wendt.m...@gmail.com>
Reply-To: "Enhanced Machine Controller (EMC)"
<emc-users@lists.sourceforge.net>
To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net>
Subject: Re: [Emc-users] linuxcnc run problems
On Tue, Aug 7, 2018, 18:41 Gene Heskett <ghesk...@shentel.net> wrote:
On Tuesday 07 August 2018 18:04:09 andy pugh wrote:
On 7 August 2018 at 20:35, Mark <wendt.m...@gmail.com> wrote:
Velocity went up to the usual and got a Joint
2 following error. None of the steppers moved. Cleared
error,clicked on orange power button, hit the home button again,
same same.
The following error really suggests a thread /configuration issue (latency
gone bad, missing thread etc etc) Almost nothing interface hardware wise
should be able to cause a following error.
I would try out stepconfs test proceedure to verify that the external
hardware/parallel ports are OK and also re-run the latency-test
...
Anybody run into this glitch before?
Stepper power OK?
db25 to the breakout half unplugged?
Nope. Checked that too and also unplugged and replugged both ends, on the
control box and computer. No difference.
Mark
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
