On 08/09/2018 08:31 AM, Gene Heskett wrote:
On Thursday 09 August 2018 07:23:58 Mark wrote:
On 08/07/2018 08:22 PM, jrmitchellj wrote:
Joint 2 error on a 2 axis machine, hmm.
Would it only have joint 0 & 1?
Is it possible you opened a 3 axis config?
J. Ray Mitchell Jr.
“No thief, however skillful, can rob one of knowledge, and that is
why knowledge is the best and safest treasure to acquire.”
-L. Frank Baum
I should have mentioned the two axes are X and Z. X is axis/joint 0
and Z is axis/joint 2.
Mark
That may work, the skipping of Y, but it may also be part of the problem.
Is lathe defined in the .ini file?
It's not a lathe, it's a saw beveler with a long X axis and a short Z
axis. It's worked that way for over 10 years now. In the docs, The Z
axis is called Axis 2. The Y axis is Axis 1 and the X axis is Axis 0.
There is no Y axis to define in the ini or hal files.
Mark
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
