Joint 2 error on a 2 axis machine, hmm. Would it only have joint 0 & 1? Is it possible you opened a 3 axis config?
J. Ray Mitchell Jr. “No thief, however skillful, can rob one of knowledge, and that is why knowledge is the best and safest treasure to acquire.” -L. Frank Baum On Tue, Aug 7, 2018, 4:35 PM Peter C. Wallace <p...@mesanet.com> wrote: > On Tue, 7 Aug 2018, Mark Wendt wrote: > > > Date: Tue, 7 Aug 2018 19:17:42 -0400 > > From: Mark Wendt <wendt.m...@gmail.com> > > Reply-To: "Enhanced Machine Controller (EMC)" > > <emc-users@lists.sourceforge.net> > > To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net > > > > Subject: Re: [Emc-users] linuxcnc run problems > > > > On Tue, Aug 7, 2018, 18:41 Gene Heskett <ghesk...@shentel.net> wrote: > > > >> On Tuesday 07 August 2018 18:04:09 andy pugh wrote: > >> > >>> On 7 August 2018 at 20:35, Mark <wendt.m...@gmail.com> wrote: > >>>> Velocity went up to the usual and got a Joint > >>>> 2 following error. None of the steppers moved. Cleared > >>>> error,clicked on orange power button, hit the home button again, > >>>> same same. > >>> > > > The following error really suggests a thread /configuration issue (latency > gone bad, missing thread etc etc) Almost nothing interface hardware wise > should be able to cause a following error. > > I would try out stepconfs test proceedure to verify that the external > hardware/parallel ports are OK and also re-run the latency-test > > > >>> ... > >>> > >>>> Anybody run into this glitch before? > >>> > >>> Stepper power OK? > >> > >> db25 to the breakout half unplugged? > >> > >> Nope. Checked that too and also unplugged and replugged both ends, on > the > > control box and computer. No difference. > > > > Mark > > > >> > >> > > > ------------------------------------------------------------------------------ > > Check out the vibrant tech community on one of the world's most > > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > Peter Wallace > Mesa Electronics > > (\__/) > (='.'=) This is Bunny. Copy and paste bunny into your > (")_(") signature to help him gain world domination. > > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
