On 08/07/2018 08:22 PM, jrmitchellj wrote:
Joint 2 error on a 2 axis machine, hmm.
Would it only have joint 0 & 1?
Is it possible you opened a 3 axis config?
J. Ray Mitchell Jr.
“No thief, however skillful, can rob one of knowledge, and that is why
knowledge is the best and safest treasure to acquire.”
-L. Frank Baum
May have been a brain fart typo on my part, I'll check that again this
afternoon when I get a chance to work on it.
Mark
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
