Ah! Was missing setp hm2_7i92.0.gpio.023.is_output true setp hm2_7i92.0.gpio.025.is_output true
All fixed now. And setting it to DB25-17 (gpio.024) which runs a relay on this little BoB I can make the relay click on and off which can run an air solenoid and give me misting. John > From: John Dammeyer [mailto:jo...@autoartisans.com] > > At the moment using the HAL meter I can switch on Coolant or Mist > > # ---coolant signals--- > net coolant-flood <= iocontrol.0.coolant-flood > net coolant-flood => hm2_7i92.0.gpio.023.out > net coolant-mist <= iocontrol.0.coolant-mist > net coolant-mist => hm2_7i92.0.gpio.025.out > > And the HAL meter shows the GPIO pins changing state when I click the check > boxes on the linuxCNC display. But for some reason the > far east simple BoB isn't reflecting that on the outputs. That's one of > those cheap BoBs that has male pins on the DB-25 rather than > female pins like most of the rest. Maybe my crimping job is suspect. > > Never seems to end does it? > > John _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
