On Wednesday 10 February 2021 20:51:47 John Dammeyer wrote:

> Ah! Was missing
> setp hm2_7i92.0.gpio.023.is_output true
> setp hm2_7i92.0.gpio.025.is_output true
>
> All fixed now.  And setting it to DB25-17  (gpio.024) which runs a
> relay on this little BoB I can make the relay click on and off which
> can run an air solenoid and give me misting. John
>
> > From: John Dammeyer [mailto:jo...@autoartisans.com]
> >
> > At the moment using the HAL meter I can switch on Coolant or Mist
> >
> > #  ---coolant signals---
> > net coolant-flood <= iocontrol.0.coolant-flood
> > net coolant-flood => hm2_7i92.0.gpio.023.out
> > net coolant-mist <= iocontrol.0.coolant-mist
> > net coolant-mist => hm2_7i92.0.gpio.025.out
> >
> > And the HAL meter shows the GPIO pins changing state when I click
> > the check boxes on the linuxCNC display.  But for some reason the
> > far east simple BoB isn't reflecting that on the outputs.  That's
> > one of those cheap BoBs that has male pins on the DB-25 rather than
> > female pins like most of the rest.  Maybe my crimping job is
> > suspect.

Be sure and put a flywheel diode on the air valve coil John. The contacts 
of that teeny little relay will last many times longer.  And the relay 
driver on the 7i92 should be checked to see if the coil is missing a 
flywheel, and add a 1N914 if there isn't one. But I expect Mesa has that 
covered though.

> > Never seems to end does it?
> >
> > John
>
> _______________________________________________
> Emc-users mailing list
> Emc-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/emc-users


Cheers, Gene Heskett
-- 
"There are four boxes to be used in defense of liberty:
 soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
If we desire respect for the law, we must first make the law respectable.
 - Louis D. Brandeis
Genes Web page <http://geneslinuxbox.net:6309/gene>


_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to