On Thu, 6 Aug 2026, Viesturs L?cis wrote:
ceturtd., 2026. g. 6. aug., plkst. 23:04 ? lietot?js Peter Wallace
(<[email protected]>) rakst?ja:
I would not expect linuxcnc to launch if the (hm2_pci) driver was invoked in
the hal file but no card was found.
like this:
hm2_pci: loading Mesa AnyIO HostMot2 driver version 0.7
hm2_pci: rtapi_app_main: No such device (-19)
and exit
oh yes, that tiny insignificant detail about loading hm2 driver that
might not be there with sim configs. ok, will check now, did not yet
remove my setup completely (we are on a family trip and I took the PC
parts in a box).
and could you please remind me of correct firmware to use with 1x 7i33
and 1x7i44 boards?
Viesturs
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
5i24_16_svss8_8.bit
Peter Wallace
Mesa Electronics
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
