Thank you! I will do that in few hours and report back Viesturs
piektd., 2026. g. 7. aug., plkst. 18:26 — lietotājs Peter Wallace (<[email protected]>) rakstīja: > > On Fri, 7 Aug 2026, Viesturs L?cis wrote: > > > ceturtd., 2026. g. 6. aug., plkst. 23:26 ? lietot?js Viesturs L?cis > > (<[email protected]>) rakst?ja: > >> > >> Thank you! Then I will take this as somewhat good news. > >> https://photos.app.goo.gl/JeXsfNADGWaLzwKk7 > >> > >> I added 2 lines in HAL file (highlighted on right side) and I started > >> LinuxCNC from terminal for easier understanding if something is wrong. > >> Looks good to me. So the question for 10K is how to flash it with > >> 5i24_16_svss8_8.bit > >> I have another machine with LinuxCNC at home that might have pci-e > >> slot to plug this in, unless the issue will move together with the > >> board > >> > > > > Hello Peter! Please comment if I am correct that board is actually > > recognized by LinuxCNC and how should I proceed with flashing it. I am > > supposed to visit customer on monday to start the retrofit, so I > > should get the pc more or less prepared. > > > > Viesturs > > > To check if the card is recognized, run: > > halcmd -kf > > halcmd: loadrt hostmot2 > halcmd: loadrt hm2_pci > > If the card is detected you should get a pin linst > > > > > > > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > Peter Wallace > Mesa Electronics > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
