----[Please read http://ercoupers.com/disclaimer.htm before following any
advice in this forum.]----
SPRUCE sells "snap vents" which are inexpensive, easy to install and very
effective. Just cut 2 inch circular holes in lower corner of windshield on
each side, and snap them in with your fingers. Make sure to carefully
measure and mark exactly where you want them, and tape with masking tape
prior to cutting with a circular saw, perhaps using a bit of WD-40 spray to
keep plexiglass cool during cutting. These are easily adjustable in flight
or on the ground, to "air in", "air exhaust", or "off". You can't beat the
price @ $8.65 a pair.
Don Bowen
[EMAIL PROTECTED]
----Original Message Follows----
From: "John Pickett" <[EMAIL PROTECTED]>
Reply-To: "John Pickett" <[EMAIL PROTECTED]>
To: <[email protected]>
Subject: [COUPERS-TECH] One more question
Date: Tue, 18 Oct 2005 20:03:32 -0500
----[Please read http://ercoupers.com/disclaimer.htm before following any
advice in this forum.]----
Hello all,, Response was great.. I will go to Terrell soon,, and see Mr.
Hardin,, It is a relief that a coupe mechanic is so close by.. The trip was
fun,, a little tiring, but a fun adventure,, Other concern,, was oil temp,,
I landed one time and let oil cool down,, I have since found that temp may
have been o.k. for my setup,, One question,, There is a small hole in the
front right of nose bowl,, about 2-3 inches in diameter,, It appears to be
just about in line with oil tank,, It had a screen over it,, Looked like
screen that is used on a house window,, anyway,, it had been completely
covered with paint.. No air flow.. On my second day of flight,, I removed
screen,, to let air flow,, It seemed to lower oil temp.. Was removing screen
a good or bad thing to do?? Is hole suppose to help cool oil tank? Thanks,
John #93735
==============================================================================
To leave this forum go to: http://ercoupers.com/lists.htm
Search the archives on http://escribe.com/aviation/coupers-tech/
==============================================================================
To leave this forum go to: http://ercoupers.com/lists.htm
Search the archives on http://escribe.com/aviation/coupers-tech/
