Since the V/U antennas are fixed (not selectable), you do not set them and consequently they will not show up assigned to RX1 or RX2.
All you have to do is set the Antenna form to Expert mode, on 6m set RX1 to ANT-1 (2 or 3) and it will be displayed on VFO-A. Turn on RX2 and select 70cm as the band and it will show up in VFO-B -Tim -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of richard allen Sent: Sunday, May 08, 2011 11:08 PM To: [email protected] Subject: [FlexEdge] 70cm/6m Running flex5000/rx2/vubox/tuner and 2.0.22 I have my 6m antenna coming in the ant1 port and 70 cm antenna into the 70cm port. I want to listen on both 70 cm and 6m at the same time. When I try to set rx2 input to antenna 1 it tells me that antenna 1 is in use by RX1. RX1 is tuned to 70 cm. How do I do this? Also, the panel shows TX:ANT1 when I would think it would show 70cm antenna. Thanks, Richard W5SXD _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software.
