Card is in interactive mode. In most cases there is incompatible code on its flash. Copy the actual running images to the mgm first, and then from there to the 10ge4. After a reset of s2 the module will run. Rgds Lutz
-----Ursprüngliche Nachricht----- Von: [email protected] [mailto:[email protected]] Im Auftrag von Remco Bressers Gesendet: Dienstag, 9. November 2010 16:58 An: [email protected] Betreff: [f-nsp] Not able to use XMR 10 gig linecard Hi, The other day, i inserted a brand new NI-XMR-10Gx4 in an XMR-4, but it won't work correctly. If i do a "show module", i see the following output on the slot : S2: NI-XMR-10Gx4 4-port 10GbE Module CARD_STATE_INTERACTIVE 20 0012.f2f5.d128 (S2: Configured as NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module) What is the correct procedure to configure S2 as ni-xmr-10gx4 ? I tried : tel...@r(config)#module 2 ni-xmr-4-port-10g Error: Please remove module from slot 2 first tel...@r(config)# Is this the only (and correct) way? -- Kind regards, Signet bv Remco Bressers _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
