Unfortunately that won't work because of the same reason : tel...@ams-er8-sara(config)#no module 2 ni-xmr-20-port-1g Error: Please remove module from slot 2 first
Also, powering off the card won't do. :( Regards, Remco On 11/09/2010 05:12 PM, Michiel Muhlenbaumer wrote: > First run 'no module blabla' and then power-off/on the lc. > > Met vriendelijke groet, > Best regards, > > Michiel Muhlenbaumer > Atrato IP Networks > > (sent from mobile device) > > On 9 nov. 2010, at 16:58, Remco Bressers <[email protected]> wrote: > >> Hi, >> >> The other day, i inserted a brand new NI-XMR-10Gx4 in an XMR-4, but it >> won't work correctly. >> If i do a "show module", i see the following output on the slot : >> >> S2: NI-XMR-10Gx4 4-port 10GbE Module CARD_STATE_INTERACTIVE 20 >> 0012.f2f5.d128 >> (S2: Configured as NI-XMR-1Gx20-SFP 20-port 1GbE/100FX Module) >> >> What is the correct procedure to configure S2 as ni-xmr-10gx4 ? >> >> I tried : >> >> tel...@r(config)#module 2 ni-xmr-4-port-10g >> Error: Please remove module from slot 2 first >> tel...@r(config)# >> >> Is this the only (and correct) way? >> >> -- >> Kind regards, >> Signet bv >> >> Remco Bressers >> _______________________________________________ >> foundry-nsp mailing list >> [email protected] >> http://puck.nether.net/mailman/listinfo/foundry-nsp -- Met vriendelijke groet, Signet bv Remco Bressers T 040 - 707 4 907 F 040 - 707 4 909 E [email protected] altijd online? www.signet.nl _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
