Hi Lyle...
OK... I just looked more carefully at the original question. I would not
recommend either method I mentioned to cut a square out of a piece of plexi. I
would do what Lyle mentioned (drill an access hole), then probably use a hand
held jig saw to do the cutting. As always with plexi, be careful when drilling
it because too much pressure can shatter it. They actually sell specialized
drill bits for plexi, but I've also had good luck with normal bits if you go
slow and easy. Sorry for the confusion... that's what happen when you start
answering before you fully understand the question!
Lyle Puente wrote:
> >I've used a table saw with good success
>
> Hi Doug,
> are you drilling an access hole to cut the opening?
>
> Lyle Puente
> PO Box 438
> Crompond, NY 10517
> [EMAIL PROTECTED]
> Global Gecko Association
> http://www.gekkota.com
>
> ###########################################################################
> THE GLOBAL GECKO ASSOCIATION LISTSERV
> WebSite: www.gekkota.com Archive: [EMAIL PROTECTED]/
> The GGA takes no responsibility for the contents of these postings.
> ###########################################################################
--
Doug Johnston
www.ncal.verio.com/~scubadug
Shop online without a credit card
http://www.rocketcash.com
RocketCash, a NetZero subsidiary
