I think you may be talking about trimming different areas of the bodywork.
When I installed my GIVI rack, I had to trim away some of the side panels
down underneath, closer to the licence plate. But, the main side frame sof
the rack are quite close to the outside surfaces of the bady panel. This
may be the area you thought was being asked about.
----- Original Message -----
From: "Kevin Harrington" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Wednesday, August 01, 2001 2:10 PM
Subject: Re: GIVI rack installation
> Perhaps there are two permutations of the mounting
> brackets or the 94's might be different than the 93's,
> but my '93 definitely needed notching--by about the
> thickness of the bracket itself--about .25". If it
> fits, great, if not, then notch it. P.S. looking @
> this bracket it would be hard to install incorrectly.
> FL Kev
>
> --- Tom Sheraden <[EMAIL PROTECTED]> wrote:
> > I agree. Beyond the obligatory slots in the rear
> > fender, I've made no modifications to mount the Givi
> > Wingrack. It is a tight fit, but it appears to be a
> > fit nonetheless.
> > -ts
> >
> > --- Michel Bijl <[EMAIL PROTECTED]> wrote:
> > > There's no need to trim the painted side panels
> > when
> > > installing the givi rack.
> >
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Make international calls for as low as $.04/minute
> > with Yahoo! Messenger
> > http://phonecard.yahoo.com/
>
>
> __________________________________________________
> Do You Yahoo!?
> Make international calls for as low as $.04/minute with Yahoo! Messenger
> http://phonecard.yahoo.com/
