I'd also make sure that braille is off under General, Core Functions.
Hth,
Tom
----- Original Message -----
From: "Steve Zielinski" <[email protected]>
To: "Chip Orange" <[email protected]>; <[email protected]>
Sent: Wednesday, February 16, 2011 9:01 PM
Subject: Re: 7.5 beta 1: Temporary loss of speech with eloquence when
working with app management area of control panel
I just checked for braille display and it says none. Right after that I
checked the app manager and this time lost speech right after entering the
list of apps. Had to hit escape twice to get back to your message. Thanks
for the idea though.
Steve
----- Original Message -----
From: Chip Orange
To: [email protected]
Sent: Wednesday, February 16, 2011 7:54 PM
Subject: RE: 7.5 beta 1: Temporary loss of speech with eloquence when
working with app management area of control panel
Steve,
Is it possible that you are not using a braille display, but your
window-eyes is set for you to have one? I have seen a report like yours,
when window-eyes has braille turned on, but there is no braille display; or
maybe it was set for a braille display, but there was no braille display
installed. anyway, if you aren't using one, make sure window-eyes is set
for no braille.
hth,
Chip
------------------------------------------------------------------------------
From: Steve Zielinski [mailto:[email protected]]
Sent: Wednesday, February 16, 2011 4:58 PM
To: [email protected]
Subject: 7.5 beta 1: Temporary loss of speech with eloquence when working
with app management area of control panel
Using window xp professional, service pack 3, 512m ram. This problem
doesn't happen with the dectalk 32 window-eyes synthesizer but does happen
with the eloquence that is tied into window-eyes, (using the Reed voice).
When I go to the app menu, then right arrow on "app management", then
arrow down to "app manager", once I hear the first item, if I down arrow to
the next item, I get temporary loss of speech. It becomes choppy, with a
few phrases of the new item being read, a five or so second pause, then a
bit more of a phrase, etc. Sometimes the speech goes out completely,
especially if I downarrow through a number of lines in that list of apps.
I get my speech back when I exit out of the control panel with the escape
a couple times. However, once I did hve to reboot by pressing the power
button for a second or so. That time, I had up and downarrowed through a
number of apps, and even after hitting escape a few times, speech didn't
return. I either wasn't patient enough to see if it did come back or it
truly was good and lost, which is why I rebooted.
This is Not happening with the decktalk 32 windo-eyes synthesizer.
Nor does it happen with either synthesizer in the "add or remove apps"
area of the app management section of control panel.
Also, unrelated, I do sense a slight sluggishness while typing this
message. I used to think that the sluggishness that has been reported was
only happening in list boxes such as indexes of email messages, or windows
explorer, etc. But there is a very slight sluggishness while writing as
well, but much less than the earlier one dealing with list boxes. I even
notice when doing a ctrl-numpad-5 key to read current line, that there is a
very slight sluggishness, compared to version 7.2. Same as I arrow through
this message I'm writing.
I'm positing this will be resolved when the issue of listbox sluggishness
is handled. I'm assuming they are related, but have no idea.
Thanks,
Steve
If you reply to this message it will be delivered to the original sender
only. If your reply would benefit others on the list and your message is
related to GW Micro, then please consider sending your message to
[email protected] so the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can
manage your list subscription at http://www.gwmicro.com/listserv.
If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list and your message is related to GW Micro, then please consider sending your message to [email protected] so the entire list will receive it.
GW-Info messages are archived at http://www.gwmicro.com/gwinfo. You can manage
your list subscription at http://www.gwmicro.com/listserv.
