Hello Robert,
On Tue, 05 Aug 2014 12:25:57 +1000, Robert Krawitz <[email protected]>
wrote:
On Tue, 05 Aug 2014 12:22:26 +1000, Terry Duell wrote:
I see the problem here, I'm running Hugin-2014.1.0 (current development
source).
When I first open your .pto all is OK, but it quickly goes haywire when
any refinement is done.
Correct, but at this point I've already performed quite a bit of
refinement without hitting the problem.
I note your comment (6), above, but wonder if you still have the problem
is you try to stitch with less overlap, say leaving out every second
image.
I can't try that here as I only have dummy images and there aren't the
control points between the non adjacent images.
Even if I remove all but one image from the viewer, I have the same
problem.
OK. Can you provide a .pto from a very early stage, i.e. prior to doing
any refinement, say just after generating control points for all images
and no optimisation steps performed?
Cheers,
--
Regards,
Terry Duell
--
A list of frequently asked questions is available at:
http://wiki.panotools.org/Hugin_FAQ
---
You received this message because you are subscribed to the Google Groups "hugin and other free panoramic software" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/hugin-ptx/op.xj3lftxbrs0ygh%40localhost.
For more options, visit https://groups.google.com/d/optout.
