Hello,
When I try to use my Hauppage PVR-500 MCE, all I get is static.
I am trying to record using the cat /dev/video0 > test.mpg and I am
also trying with mythtv.
Sometimes, I can get a very staticy channel, but I can sort of make
out the picture that's coming in.
dmesg:
[42949389.450000] Linux video capture interface: v1.00
[42949389.530000] ivtv: ==================== START INIT IVTV
====================
[42949389.530000] ivtv: version 0.7.3 (tagged release) loading
[42949389.530000] ivtv: Linux version: 2.6.17-10-server SMP
mod_unload 686 REGPARM gcc-4.1
[42949389.530000] ivtv: In case of problems please include the debug
info between
[42949389.530000] ivtv: the START INIT IVTV and END INIT IVTV lines, along with
[42949389.530000] ivtv: any module options, when mailing the
ivtv-users mailinglist.
[42949389.530000] ivtv0: Autodetected Hauppauge WinTV PVR-150 card
(cx23416 based)
[42949389.530000] ACPI: PCI Interrupt 0000:02:08.0[A] -> Link [LNK1]
-> GSI 11 (level, low) -> IRQ 11
[42949389.530000] ivtv0: Unreasonably low latency timer, setting to 64 (was 32)
[42949389.600000] tveeprom 1-0050: Hauppauge model 23552, rev E687,
serial# 10024648
[42949389.600000] tveeprom 1-0050: tuner model is Samsung TCPN
2121P30A (idx 87, type 70)
[42949389.600000] tveeprom 1-0050: TV standards NTSC(M) (eeprom 0x08)
[42949389.600000] tveeprom 1-0050: second tuner model is Philips
TEA5768HL FM Radio (idx 101, type 62)
[42949389.600000] tveeprom 1-0050: audio processor is CX25843 (idx 37)
[42949389.600000] tveeprom 1-0050: decoder processor is CX25843 (idx 30)
[42949389.600000] tveeprom 1-0050: has radio, has no IR remote
[42949389.600000] ivtv0: This is the second unit of a PVR500
[42949389.600000] ivtv0: Correcting tveeprom data: no radio present on
second unit
[42949389.710000] tuner 1-0060: TEA5767 detected.
[42949389.710000] tuner 1-0060: chip found @ 0xc0 (ivtv i2c driver #0)
[42949389.710000] tuner 1-0060: type set to 62 (Philips TEA5767HN FM Radio)
[42949389.710000] tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #0)
[42949390.090000] cx25840 1-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #0)
[42949395.770000] cx25840 1-0044: loaded v4l-cx25840.fw firmware (16382 bytes)
[42949395.900000] wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #0)
[42949396.640000] ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
[42949396.860000] ivtv0: Encoder revision: 0x02050032
[42949396.860000] ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768
buffers (4096KB total)
[42949396.860000] ivtv0: Allocate DMA encoder YUV stream: 194 x 10800
buffers (2048KB total)
[42949396.860000] ivtv0: Allocate DMA encoder VBI stream: 120 x 17472
buffers (2048KB total)
[42949396.860000] ivtv0: Allocate DMA encoder PCM audio stream: 455 x
4608 buffers (2048KB total)
[42949396.860000] tuner 1-0061: type set to 70 (Samsung TCPN 2121P30A)
[42949397.050000] ivtv0: Initialized WinTV PVR 500 (unit #2), card #0
[42949397.050000] ivtv: ====================== NEXT CARD
======================
[42949397.050000] ivtv1: Autodetected Hauppauge WinTV PVR-150 card
(cx23416 based)
[42949397.060000] ACPI: PCI Interrupt Link [LNK2] enabled at IRQ 5
[42949397.060000] PCI: setting IRQ 5 as level-triggered
[42949397.060000] ACPI: PCI Interrupt 0000:02:09.0[A] -> Link [LNK2]
-> GSI 5 (level, low) -> IRQ 5
[42949397.060000] ivtv1: Unreasonably low latency timer, setting to 64 (was 32)
[42949397.150000] tuner 2-0061: chip found @ 0xc2 (ivtv i2c driver #1)
[42949397.450000] cx25840 2-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #1)
[42949398.490000] eth1: network connection up using port A
[42949398.490000] speed: 1000
[42949398.490000] autonegotiation: yes
[42949398.490000] duplex mode: full
[42949398.490000] flowctrl: symmetric
[42949398.490000] role: slave
[42949398.490000] irq moderation: disabled
[42949398.490000] scatter-gather: enabled
[42949398.490000] tx-checksum: enabled
[42949398.490000] rx-checksum: enabled
[42949398.490000] rx-polling: enabled
[42949403.120000] cx25840 2-0044: loaded v4l-cx25840.fw firmware (16382 bytes)
[42949403.230000] wm8775 2-001b: chip found @ 0x36 (ivtv i2c driver #1)
[42949403.330000] tveeprom 2-0050: Hauppauge model 23552, rev E687,
serial# 10024648
[42949403.330000] tveeprom 2-0050: tuner model is Samsung TCPN
2121P30A (idx 87, type 70)
[42949403.330000] tveeprom 2-0050: TV standards NTSC(M) (eeprom 0x08)
[42949403.330000] tveeprom 2-0050: second tuner model is Philips
TEA5768HL FM Radio (idx 101, type 62)
[42949403.330000] tveeprom 2-0050: audio processor is CX25843 (idx 37)
[42949403.330000] tveeprom 2-0050: decoder processor is CX25843 (idx 30)
[42949403.330000] tveeprom 2-0050: has radio, has no IR remote
[42949403.330000] ivtv1: This is the first unit of a PVR500
[42949403.380000] NET: Registered protocol family 17
[42949403.790000] NET: Registered protocol family 10
[42949403.790000] lo: Disabled Privacy Extensions
[42949403.790000] IPv6 over IPv4 tunneling driver
[42949404.090000] ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
[42949404.310000] ivtv1: Encoder revision: 0x02050032
[42949404.310000] ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768
buffers (4096KB total)
[42949404.310000] ivtv1: Allocate DMA encoder YUV stream: 194 x 10800
buffers (2048KB total)
[42949404.310000] ivtv1: Allocate DMA encoder VBI stream: 120 x 17472
buffers (2048KB total)
[42949404.310000] ivtv1: Allocate DMA encoder PCM audio stream: 455 x
4608 buffers (2048KB total)
[42949404.310000] ivtv1: Create encoder radio stream
[42949404.310000] tuner 2-0061: type set to 70 (Samsung TCPN 2121P30A)
[42949404.500000] ivtv1: Initialized WinTV PVR 500 (unit #1), card #1
[42949404.500000] ivtv: ==================== END INIT IVTV
====================
Currently, I am trying to use ivtv 0.7.3, but I was previously trying
0.7.0 (the standard ubuntu edgy version)
My card has the samsung tv tuner chipsets, which I've read cause some issues.
relevant lspci -v output:
02:08.0 Multimedia video controller: Internext Compression Inc iTVC16
(CX23416) MPEG-2 Encoder (rev 01)
Subsystem: Hauppauge computer works Inc. Unknown device 17f7
Flags: bus master, medium devsel, latency 64, IRQ 11
Memory at e0000000 (32-bit, prefetchable) [size=64M]
Capabilities: [44] Power Management version 2
02:09.0 Multimedia video controller: Internext Compression Inc iTVC16
(CX23416) MPEG-2 Encoder (rev 01)
Subsystem: Hauppauge computer works Inc. Unknown device 17e7
Flags: bus master, medium devsel, latency 64, IRQ 5
Memory at e4000000 (32-bit, prefetchable) [size=64M]
Capabilities: [44] Power Management version 2
Originally, I followed the ubuntu edgy ivtv guide at
https://help.ubuntu.com/community/Install_IVTV_Edgy
But then I downloaded and installed 0.7.3 from source because I didn't
have them available in ubuntu's own repositories.
Right now, cat /proc/version gives (for ubuntu edgy server)
Linux version 2.6.17-10-server ([EMAIL PROTECTED]) (gcc version 4.1.2
20060928 (prerelease) (Ubuntu 4.1.1-13ubuntu5)) #2 SMP Tue Dec 5
22:29:32 UTC 2006 (Ubuntu 2.6.17-10.34-server)
Thanks in advance
~Matt
_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users
