I may have spoke too soon as another problem creeped in.

One tuner ended up recording bad video till I rebooted.  I saw this before 
with the jiffies but nothing popped up in my logs during my test.

This is before the reboot: (all the other tuners output was OK and this 
one was the one that recorded the bad video)

v4l2-ctl --all --device=/dev/video0
Driver info:
         Driver name   : ivtv
         Card type     : WinTV PVR 500 (unit #1)
         Bus info      : 0000:02:08.0
         Driver version: 65536
         Capabilities  : 0x01070051
                 Video Capture
                 VBI Capture
                 Sliced VBI Capture
                 Tuner
                 Audio
                 Radio
                 Read/Write
Format:
         Type          : Video Capture
         Width/Height  : 720/480
         Pixel Format  : MPEG
         Field         : Interlaced
         Bytes per Line: 0
         Size Image    : 131072
         Colorspace    : Broadcast NTSC/PAL (SMPTE170M/ITU601)
Format:
         Type           : Sliced VBI Capture
         Service Set    :
         Service Line  0:          /
         Service Line  1:          /
         Service Line  2:          /
         Service Line  3:          /
         Service Line  4:          /
         Service Line  5:          /
         Service Line  6:          /
         Service Line  7:          /
         Service Line  8:          /
         Service Line  9:          /
         Service Line 10:          /
         Service Line 11:          /
         Service Line 12:          /
         Service Line 13:          /
         Service Line 14:          /
         Service Line 15:          /
         Service Line 16:          /
         Service Line 17:          /
         Service Line 18:          /
         Service Line 19:          /
         Service Line 20:          /
         Service Line 21:          /
         Service Line 22:          /
         Service Line 23:          /
         I/O Size       : 0
Format:
         Type            : VBI Capture
         Sampling Rate   : 27000000 Hz
         Offset          : 248 samples (9.18519e-06 secs after leading 
edge)
         Samples per Line: 1440
         Sample Format   : GREY
         Start 1st Field : 10
         Count 1st Field : 12
         Start 2nd Field : 273
         Count 2nd Field : 12
Video input : 0 (Tuner 1)
Audio input : 0 (Tuner 1)
Frequency: 2900 (181.250000 MHz)
Video standard = 0x0000b000
         NTSC-M/M-JP/M-KR
Tuner:
         Capabilities         : 62.5 kHz multi-standard stereo lang1 lang2
         Frequency range      : 44.0 MHz - 958.0 MHz
         Signal strength      : 100%
         Current audio mode   : lang1
         Available subchannels: mono

===========================================

After the reboot the only part that changed is after the Available 
subchannels:

Tuner:
         Capabilities         : 62.5 kHz multi-standard stereo lang1 lang2
         Frequency range      : 44.0 MHz - 958.0 MHz
         Signal strength      : 100%
         Current audio mode   : lang1
         Available subchannels: stereo lang2

-

Would that cause the video to go garbled?  I am recording 720x480 with 
mythtv.

Any ideas where I can go from here?  I'm going to test again to see if I 
can make it repeat.

Thanks,

Jason

---
dmesg | grep -i ivtv
[   58.597696]  sdd:<6>ivtv:  ==================== START INIT IVTV 
====================
[   58.603663] ivtv:  version 1.0.0 (2.6.22-14-generic SMP mod_unload ) 
loading
[   58.603764] ivtv0: Autodetected Hauppauge card (cx23416 based)
[   59.373332] ivtv0: loaded v4l-cx2341x-enc.fw firmware (-139637080215088 
bytes)
[   59.591969] ivtv0: Encoder revision: 0x02060039
[   59.647735] ivtv0: Autodetected WinTV PVR 500 (unit #1)
[   59.670305] tuner 2-0043: chip found @ 0x86 (ivtv i2c driver #0)
[   59.673895] tuner 2-0060: chip found @ 0xc0 (ivtv i2c driver #0)
[   59.674129] tuner 2-0061: chip found @ 0xc2 (ivtv i2c driver #0)
[   59.705722] cx25840 2-0044: cx25843-24 found @ 0x88 (ivtv i2c driver 
#0)
[   63.021163] wm8775 2-001b: chip found @ 0x36 (ivtv i2c driver #0)
[   63.382185] ivtv0: Registered device video0 for encoder MPEG (4 MB)
[   63.382452] ivtv0: Registered device video32 for encoder YUV (2 MB)
[   63.382739] ivtv0: Registered device vbi0 for encoder VBI (1 MB)
[   63.382930] ivtv0: Registered device video24 for encoder PCM audio (1 
MB)
[   63.383218] ivtv0: Registered device radio0 for encoder radio
[   63.406553] ivtv0: Initialized WinTV PVR 500 (unit #1), card #0
[   63.406626] ivtv:  ======================  NEXT CARD 
======================
[   63.406629] ivtv1: Autodetected Hauppauge card (cx23416 based)
[   64.048450] ivtv1: loaded v4l-cx2341x-enc.fw firmware (-139637080213760 
bytes)
[   64.263407] ivtv1: Encoder revision: 0x02060039
[   64.267976] tuner 3-0043: chip found @ 0x86 (ivtv i2c driver #1)
[   64.270974] tuner 3-0061: chip found @ 0xc2 (ivtv i2c driver #1)
[   64.286105] cx25840 3-0044: cx25843-24 found @ 0x88 (ivtv i2c driver 
#1)
[   67.584538] wm8775 3-001b: chip found @ 0x36 (ivtv i2c driver #1)
[   67.647053] ivtv1: Correcting tveeprom data: no radio present on second 
unit
[   67.647055] ivtv1: Autodetected WinTV PVR 500 (unit #2)
[   68.017739] ivtv1: Registered device video1 for encoder MPEG (4 MB)
[   68.018030] ivtv1: Registered device video33 for encoder YUV (2 MB)
[   68.018333] ivtv1: Registered device vbi1 for encoder VBI (1 MB)
[   68.018541] ivtv1: Registered device video25 for encoder PCM audio (1 
MB)
[   68.040876] ivtv1: Initialized WinTV PVR 500 (unit #2), card #1
[   68.047226] ivtv:  ======================  NEXT CARD 
======================
[   68.047233] ivtv2: Autodetected Hauppauge card (cx23416 based)
[   68.686604] ivtv2: loaded v4l-cx2341x-enc.fw firmware (-139637080212896 
bytes)
[   68.902880] ivtv2: Encoder revision: 0x02060039
[   68.907484] tuner 4-0043: chip found @ 0x86 (ivtv i2c driver #2)
[   68.911132] tuner 4-0060: chip found @ 0xc0 (ivtv i2c driver #2)
[   68.911372] tuner 4-0061: chip found @ 0xc2 (ivtv i2c driver #2)
[   68.926505] cx25840 4-0044: cx25843-24 found @ 0x88 (ivtv i2c driver 
#2)
[   72.230235] wm8775 4-001b: chip found @ 0x36 (ivtv i2c driver #2)
[   72.293951] ivtv2: Autodetected WinTV PVR 500 (unit #1)
[   72.661214] ivtv2: Registered device video2 for encoder MPEG (4 MB)
[   72.661499] ivtv2: Registered device video34 for encoder YUV (2 MB)
[   72.661791] ivtv2: Registered device vbi2 for encoder VBI (1 MB)
[   72.661993] ivtv2: Registered device video26 for encoder PCM audio (1 
MB)
[   72.662312] ivtv2: Registered device radio2 for encoder radio
[   72.685985] ivtv2: Initialized WinTV PVR 500 (unit #1), card #2
[   72.686057] ivtv:  ======================  NEXT CARD 
======================
[   72.686060] ivtv3: Autodetected Hauppauge card (cx23416 based)
[   73.327524] ivtv3: loaded v4l-cx2341x-enc.fw firmware (-139637080211856 
bytes)
[   73.542349] ivtv3: Encoder revision: 0x02060039
[   73.546990] tuner 5-0043: chip found @ 0x86 (ivtv i2c driver #3)
[   73.549988] tuner 5-0061: chip found @ 0xc2 (ivtv i2c driver #3)
[   73.565123] cx25840 5-0044: cx25843-24 found @ 0x88 (ivtv i2c driver 
#3)
[   76.868814] wm8775 5-001b: chip found @ 0x36 (ivtv i2c driver #3)
[   76.931711] ivtv3: Correcting tveeprom data: no radio present on second 
unit
[   76.931713] ivtv3: Autodetected WinTV PVR 500 (unit #2)
[   77.300707] ivtv3: Registered device video3 for encoder MPEG (4 MB)
[   77.301020] ivtv3: Registered device video35 for encoder YUV (2 MB)
[   77.301342] ivtv3: Registered device vbi3 for encoder VBI (1 MB)
[   77.301575] ivtv3: Registered device video27 for encoder PCM audio (1 
MB)
[   77.323913] ivtv3: Initialized WinTV PVR 500 (unit #2), card #3
[   77.323935] ivtv:  ====================  END INIT IVTV 
====================


_______________________________________________
ivtv-users mailing list
[email protected]
http://ivtvdriver.org/mailman/listinfo/ivtv-users

Reply via email to