Interesting... perhaps a small bug. When you say latest.. I've just tried this out on: 2009-02016 final
What you say works ON THE MAIN PCB LAYOUT when you draw an arc on the edges layer. Here we are talking about the module editor where what you say does NOT work. If you end the tool and double click on the arc you get the module properties window, not anything to do with the arc. Andy On 24 Mar 2009 07:06:10 -0000 "cv sandeep" <[email protected]> wrote: > HI > If you are using the latest version of Kicad then Just draw a small arc using > the arc tool and the double click on it then a window opens enter the arc > angle value as 2700 and give ok > > Regards, > Sandeep > > > On Fri, 20 Mar 2009 Andy Eskelson wrote : > >On Fri, 20 Mar 2009 04:57:52 -0000 > >"Daniel CORRE" <[email protected]> wrote: > >The drawing tools are a bit crude and awkward, but it is possible once > >you get the hang of them. > > > >You use the arc tool. > >The arc tool draws 1/4 of a circle, so you use several arcs. > >You always start at the centre of the circle, so. > > > >Select the arc tool. > > > >(assume 4 grid points is the size) > > > >Click in the centre of the circle that > >the arcs will lie on. > > > >Move up 4 points. click to end > > > >click back on centre > >Move left 4 points click to end > > > >Click back on centre > >move down 4 points click to end. > > > >You should have your 270 degree arc now. > > > >You can move the position of the arc about by varyong the direction you > >pull the radius out, takes a bit of practice. Stick with the up down left > >and right until you get the hang of it. > > > >Hope this helps. > > > >Andy > > > > > > > > > > > > > > > How is it possible to draw a 270 ° arc of circle in a module design ? > > > I've put a open office 3 file to better explain my problem in the folder > > > called daniel's problem. > > > > > > Thanks to everyone who can help me. > > > > > > Regards, > > > Daniel > > > > > > > > > > > > ------------------------------------ > > > > > > Please read the Kicad FAQ in the group files section before posting your > > > question. > > > Please post your bug reports here. They will be picked up by the creator > > > of Kicad. > > > Please visit http://www.kicadlib.org for details of how to contribute > > > your symbols/modules to the kicad library. > > > For building Kicad from source and other development questions visit the > > > kicad-devel group at http://groups.yahoo.com/group/kicad-develYahoo! > > > Groups Links > > > > > > > > >
