ur very correct buddy!
On Tue, 24 Mar 2009 Andy Eskelson wrote : >Interesting... >perhaps a small bug. > >When you say latest.. I've just tried this out on: >2009-02016 final > > >What you say works ON THE MAIN PCB LAYOUT when you draw an arc on the >edges layer. > >Here we are talking about the module editor where what you say does NOT >work. If you end the tool and double click on the arc you get the module >properties window, not anything to do with the arc. > > > >Andy > > > > >On 24 Mar 2009 07:06:10 -0000 >"cv sandeep" <[email protected]> wrote: > > > HI > > If you are using the latest version of Kicad then Just draw a small arc > > using the arc tool and the double click on it then a window opens enter the > > arc angle value as 2700 and give ok > > > > Regards, > > Sandeep > > > > > > On Fri, 20 Mar 2009 Andy Eskelson wrote : > > >On Fri, 20 Mar 2009 04:57:52 -0000 > > >"Daniel CORRE" <[email protected]> wrote: > > >The drawing tools are a bit crude and awkward, but it is possible once > > >you get the hang of them. > > > > > >You use the arc tool. > > >The arc tool draws 1/4 of a circle, so you use several arcs. > > >You always start at the centre of the circle, so. > > > > > >Select the arc tool. > > > > > >(assume 4 grid points is the size) > > > > > >Click in the centre of the circle that > > >the arcs will lie on. > > > > > >Move up 4 points. click to end > > > > > >click back on centre > > >Move left 4 points click to end > > > > > >Click back on centre > > >move down 4 points click to end. > > > > > >You should have your 270 degree arc now. > > > > > >You can move the position of the arc about by varyong the direction you > > >pull the radius out, takes a bit of practice. Stick with the up down left > > >and right until you get the hang of it. > > > > > >Hope this helps. > > > > > >Andy > > > > > > > > > > > > > > > > > > > > > > How is it possible to draw a 270 ð arc of circle in a module design ? > > > > I've put a open office 3 file to better explain my problem in the > > > > folder called daniel's problem. > > > > > > > > Thanks to everyone who can help me. > > > > > > > > Regards, > > > > Daniel > > > > > > > > > > > > > > > > ------------------------------------ > > > > > > > > Please read the Kicad FAQ in the group files section before posting > > > > your question. > > > > Please post your bug reports here. They will be picked up by the > > > > creator of Kicad. > > > > Please visit http://www.kicadlib.org for details of how to contribute > > > > your symbols/modules to the kicad library. > > > > For building Kicad from source and other development questions visit > > > > the kicad-devel group at > > > > http://groups.yahoo.com/group/kicad-develYahoo! Groups Links > > > > > > > > > > > >
