Date: Sun, 08 Apr 2001 14:22:55 -0700
From: Karen R <[EMAIL PROTECTED]>
Subject: Re: 100CT PCMCIA Problem

Hi Paul,

Hmmm, when I go into the Add New Hardware wizard
in the Control Panel and select "No, I want to select the
hardware from a list" rather than let Windows find it...
it brings up a list which has PCMCIA socket on it...

Do you get that on your list too???

If you do, then you select it and go from there...

BTW, I always do a custom install of any Windoz
product... gives more control over the end result
that way.  It brings up screens not seen otherwise,
like selecting other hardware that is not detected
by Windoz.

Karen

Paul Betts wrote:

> Date: Sun, 8 Apr 2001 21:55:16 +0100
> From: "Paul Betts" <[EMAIL PROTECTED]>
> Subject: Re: 100CT PCMCIA Problem
>
> Hi Karen,
>
> Thanks for your prompt reply, I did try and use the trouble shooter this
> morning (before I sent my initial mail). For PCMCIA problems it was not that
> much cop.
>
> In the help, there was a was an option to "enable 32-bit card support"
> (using the PC Card (PCMCIA) wizard. I selected this option and it said it
> was not installed and that I should goto to Add/REmove Programs for the
> Windows setup.
>
> There is NO entry in the windows setup to configure PCMCIA Cards or the Card
> services.
>
> So thats a bit of a dead end.
>
> > Fixing Big Problems with System Troubleshooter
>
> <snip>
>
> > 1.Launch System Troubleshooter by clicking the Start button
> >    and selecting Run. When the Run dialog box appears, type
> >   tshoot in the Open box, and then click OK.
>
> Tried this, there is no tshoot applicaiton on my machine :-(
>
> There is NO entry on PCMCIA Socket wihin the Device Manager for "PCMCIA Card
> Services".
>
> ******The question is "How do I the above PCMCIA Card Services
> ?????"*********
>
> Other useful information that may help is that when I add or remove a PCMCIA
> card, the following message box appears:
>
> "Windows is not able to identify or use the inserted PC Card device because
> there is no memory area available to communicate with the device. You must
> make a memory area available before this device can be used.Check your
> computer's CONFIG.SYS file for a memory manager that is excluding upper
> memory regions between A000 and FFFF."
>
> I don't have any entries in my config.sys that reference any memory settings
> :-(
>
> Thanks for your help so far
>
> Cheers
>
> Paul




**************************************************************
http://libretto.basiclink.com - Libretto mailing list                
http://libretto.basiclink.com/archive - Archives
http://www.picante.com/~gtaylor/portable/faq.html - FAQ         
                 -------UNSUBSCRIBE-------                            
mailto:[EMAIL PROTECTED]?subject=cmd:unsubscribe 
            --------UNSUBSCRIBE DIGEST------
Use above but add DIGEST to the subject line...                           
**************************************************************

Reply via email to