As I said we can rule out the faulty movie, there is merely something
more than this script. It's my stub who does a screen size check and
then enables a continue button that loads the "real" project. When I
run it on this G4 it launches and then just stays on frame 1, passes
the alerts and then freezes ???. I don't know, the last thing I tried
was the debugenabled but message window doesn't pop up.
Make sure to use the proper syntax, it's 'the debugPlaybackEnabled' and
make sure you don't set it to false as once you do the Message window
_cannot_ be opened again during that same projector session (so if you
first set it to false then later back to true it will not open).
It doesn't open the message window on the Mac - it writes to a log.
Here's the info from the docs...
"Player property; in Windows, opens a Message window for debugging
purposes in Shockwave and projectors. On the Macintosh, a log file is
generated to allow put statements to output data for debugging
purposes. Read/write.
In Windows, this property does not have any effect when used in the
Director application. Once the Message window is closed, it cannot be
reopened for a particular Shockwave Player or projector session. If
more than one movie with Shockwave content uses this script in a single
browser, only the first will open a Message window, and the Message
window will be tied to the first movie alone.
On the Macintosh, the generated log file is located in the Shockwave
Player folder at HardDrive/System
Folder/Extensions/Macromedia/Shockwave."
hth,
Kurt
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/lingo-l.cgi To post messages to the list, email
lingo-l@penworks.com (Problems, email [EMAIL PROTECTED]). Lingo-L is for
learning and helping with programming Lingo. Thanks!]