Hi,
Always with my dosemu 1.0.2 and A D-Link network card.
In my dosemu.conf :
$_ipxsupport = (on)
$_novell_hack = (on)
$_vnet = (on)
I try to use a netware client ( NETX with lsl ...) and I don't arrive to
load the driver of the network card : DLINK, and I obtain this result
whan I try to launch the driver of the card after the lauch of lsl.exe
C:\NWCLIENT>dlkfet
D-Link DFE-530TX PCI Fast Ethernet Adapter MLID v2.39 (990119)
Copyright D-Link Corporation 1999. All right reserved.
Slot 255, IRQ 5, Port 300
Max Frame 1514 bytes, Line Speed 10 Mbps, Half-Duplex
Board 1, Frame ETHERNET_802.3, LSB Mode
FATAL: VT86C100A Does not support this bus type
DLKFET-DOS-6: The adapter did not initialize. DLKFET did not load.
Could you help me, PLEASE !!!
Regards.
Lionel DARNIS
-
To unsubscribe from this list: send the line "unsubscribe linux-msdos" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
