Hi
Did you :
1) Enable PCI in dosemu.conf ie. $_pci = (on)
2) Pass the IO range & IRQ of the card using the $_ports (Eg. $_ports =
"range 0x1000,0x10FF") & $_irqpassing (Eg. $_irqpassing = "11")
3) Try loading the driver in MSDOS & did it load properly ?
Most likely (1) might solve your problem.
Sreeji
On 12 Sep 2001, Lionel DARNIS wrote:
>
> Hi,
>
> Always with my dosemu 1.0.2 and A D-Link network card.
> In my dosemu.conf :
>
> $_ipxsupport = (on)
> $_novell_hack = (on)
> $_vnet = (on)
>
> I try to use a netware client ( NETX with lsl ...) and I don't arrive to
> load the driver of the network card : DLINK, and I obtain this result
> whan I try to launch the driver of the card after the lauch of lsl.exe
>
> C:\NWCLIENT>dlkfet
> D-Link DFE-530TX PCI Fast Ethernet Adapter MLID v2.39 (990119)
> Copyright D-Link Corporation 1999. All right reserved.
>
> Slot 255, IRQ 5, Port 300
> Max Frame 1514 bytes, Line Speed 10 Mbps, Half-Duplex
> Board 1, Frame ETHERNET_802.3, LSB Mode
>
> FATAL: VT86C100A Does not support this bus type
>
> DLKFET-DOS-6: The adapter did not initialize. DLKFET did not load.
>
> Could you help me, PLEASE !!!
>
> Regards.
>
> Lionel DARNIS
>
>
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-msdos" in
> the body of a message to [EMAIL PROTECTED]
> More majordomo info at http://vger.kernel.org/majordomo-info.html
>
-
To unsubscribe from this list: send the line "unsubscribe linux-msdos" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
