Dear Sreeji,
Since I put $_pci = (on) and $_irqpassing the dosemu block when I load
the driver of the Network card.
An Idea ?
About the point 3, the card work fine under msdos
Lionel
> Hi
>
> Did you :
> 1) Enable PCI in dosemu.conf ie. $_pci = (on)
> 2) Pass the IO range & IRQ of the card using the $_ports (Eg. $_ports =
> "range 0x1000,0x10FF") & $_irqpassing (Eg. $_irqpassing = "11")
> 3) Try loading the driver in MSDOS & did it load properly ?
>
> Most likely (1) might solve your problem.
>
> Sreeji
>
> On 12 Sep 2001, Lionel DARNIS wrote:
>
> >
> > Hi,
> >
> > Always with my dosemu 1.0.2 and A D-Link network card.
> > In my dosemu.conf :
> >
> > $_ipxsupport = (on)
> > $_novell_hack = (on)
> > $_vnet = (on)
> >
> > I try to use a netware client ( NETX with lsl ...) and I don't arrive to
> > load the driver of the network card : DLINK, and I obtain this result
> > whan I try to launch the driver of the card after the lauch of lsl.exe
> >
> > C:\NWCLIENT>dlkfet
> > D-Link DFE-530TX PCI Fast Ethernet Adapter MLID v2.39 (990119)
> > Copyright D-Link Corporation 1999. All right reserved.
> >
> > Slot 255, IRQ 5, Port 300
> > Max Frame 1514 bytes, Line Speed 10 Mbps, Half-Duplex
> > Board 1, Frame ETHERNET_802.3, LSB Mode
> >
> > FATAL: VT86C100A Does not support this bus type
> >
> > DLKFET-DOS-6: The adapter did not initialize. DLKFET did not load.
> >
> > Could you help me, PLEASE !!!
> >
> > Regards.
> >
> > Lionel DARNIS
> >
> >
> >
> > -
> > To unsubscribe from this list: send the line "unsubscribe linux-msdos" in
> > the body of a message to [EMAIL PROTECTED]
> > More majordomo info at http://vger.kernel.org/majordomo-info.html
> >
-
To unsubscribe from this list: send the line "unsubscribe linux-msdos" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
