Kari Suomela wrote:
>
Hi there,
> This is now my 'insert':
>
> === Cut ===
> #!/bin/bash
> isapnp ./isapnp.conf
Did you make a pnpdump > /installation/path/modules/isapnp.conf? Then
it's right. The path must be to the correct isapnp.conf.
> insmod ./ftape.o ft_fdc_driver=ftape-internal,bpck-fdc:trakker,none,
> none ft_tracings=3,3,3,3,3
> insmod ./zftape.o ft_major_device_number=27 # ${27-FT_MAJOR}
My insert just says the same. I have the compressor module enabled.
But you don't need this.
> insmod ./ftape-internal.o ft_fdc_fc10=0 ft_fdc_mach2=0 ft_fdc_base=
> 0x210 ft_fdc_dma=0 ft_fdc_threshold=15 # ft_fdc_rate_limit=4000
Should work if:
0x210 is your IO-Port (as found while pnpdump > isapnpn.conf)
0 is your DMA channel (as found while pnpdump > isapnpn.conf)
15 is your IRQ (as found while pnpdump > isapnpn.conf)
All these parameters must be enabled in your isapnp.conf.
Be careful: 15 is the secondary IDE IRQ. Perhaps you need it. Then you
should interview your isapnp.conf whether you can take different one.
Furthermore I enabled ft_fdc_rate_limit with the maximum at 3000.
> /usr/sbin/klogd -i
I disabled this line because my klogd doesn't understand -i and I
didn't know what -i should do.
Hope it helps.
Carsten
--
"Etwas nicht tun zu koennen, ist kein Grund, es nicht zu tun."
Gordon "Alf" Shummway
Registered Linux User: 106265
